Build Small Mirrored Nightstand – Persons such as mirrored furniture to build their own mirrored bedside use of materials which can be purchased at home improvement or hardware stores. Nightstand construction, measure, marks and cut five pieces are the middle, bottom, top and sides shelf of your nightstand.
Measure, mark and cut two pieces and long measure, this is the back and front of your small mirrored nightstand. Put two side pieces along the sides of the 16-inch from the bottom. The 24-inch long edges must be in a vertical position. Secure the sides to the bottom with the aid of 1-inch wood screws at all four cutting corners. next, replace the piece upside created in step 2 so that fits snugly between the parties. Protect the top on the sides with the aid of 1-inch wood screws at all four cutting corners.
Next, measure from the top of the bottom of the small mirrored nightstand. Mark the measurement on both sides. Slide the middle shelf between partners of the bedside table directly above the measurements. Secure the middle board in place with the aid of 1-inch wood screws at all four cutting corners. Centered rear of the bedside table at the bottom, top and sides. Centered front of the bedside table at the bottom, top and sides. Mirroring process, Measure and mark 3 pieces of mirror so that they measure wide and long. Wet cutting wheel on the glass cutter with water. Align the metal measure along the first cut line, Downward on the cutter and pull the glass cutter along the length of the mark. Place silicone caulk into the caulking gun. Run a bead of caulk around the edges of the one end. Walk diagonally beads of caulk between the corners. Centers the right mirror piece on the side. Press keeps the side against the adhesive bead and in place until the adhesive cools and hardens. DAB small amount of caulk in the area where you installed the cabinet button. Push the button housing gently on the caulk and press firmly on the surface. Scrape away excess caulk with a razor after the caulk has dried. Clean the mirrored surface with glass cleaner and a paper towel to remove the finger is printed.