Custom bathroom vanities– Trace the outline with a wheel to dial, making sure to press hard enough for the wheel to stop cracks in the wood below the pattern. Remove the pattern. Mark the location of the holes for the faucet with a pencil, using the manufacturer’s instructions to remove the spout and handles behind the sink. Remove the dresser drawers and determines which affect the basin, water pipes and drainage. Unscrew the top panel of the dresser. Cut the top of the dresser and reinforcement of plywood around the edge of the sink. Cut the opening for the pipes at the back of the dresser with the jig.
Clear silicone adhesive applied at the edges of the opening and place the sink. Install faucets and water pipes subject, following the manufacturer’s recommendations to seal and adjust. Connect the sink with drain pipe. Sella under the sink according to the manufacturer’s instructions.
Apply glue around the inside edge of the front of each drawer above the toilet you cut and paste. Replace the rest of the custom bathroom vanities. Apply at least two coats of polyurethane to the top of the toilet with a brush.