Make a wooden kitchen cabinet knobs that match the furniture will add a nice complement to the piece. Instructions: Locate the center of the section of plywood 1/2 by 3 by 3 inches (1.27 by 7.61 by 7.61 cm) by drawing a line around opposite corners with a ruler and a pencil. The point where the lines intersect is the center. Is 1 1/4 inches (3.17 cm) from the center of each of the lines extending to the corners. Brand measurements with a pencil.
Use a drill with 7/8 inch (2.22 cm) to drill a hole through the wood section in each of the pencil marks.
Use a hole saw 2 1/8 inches (5.39 cm) and drill to cut a hole in the section of plywood. The party will cut kitchen cabinet knobs. Use a drill 5/16 inch (0.79 cm) to drill a hole through the center of the knob. Lija knob with sandpaper grit 120. Aplícale a wood finish of your choice to the knob. Allow the finish to dry.
11 Photos Gallery of: Make a Wood Kitchen Cabinet Knobs
1/4 bolt inserted (0.63 cm) through the center hole of the knob. Slide a washer 1/4 over the threaded end of the bolt. Squeeze 1/4 inch nut onto the bolt and tighten it by hand to ensure the kitchen cabinet knobs bolt. Use the washer and the remaining nut to install the knob on your project.